Tips 'n' Tricks

Machine settings for different materials

Magnet Material		Stencil Material
Thickness: Blade & Housing: Speed: Pressure: Blade Depth: Multi Cut:	0.035" / 0.80mm Deep Cut 3 Med 5 Max 6 4	Thickness: Blade & Housing: Speed: Pressure: Blade Depth: Multi Cut:	0.0155" / 0.40mm Standard 3 Med 5 Max 6 2
		Notes: Adhesive is repositionable. Replace liner to protect adhesive during storage.
Chipboard		Iron-on Fabric
Thickness: Blade & Housing: Speed: Pressure: Blade Depth: Multi Cut:	0.059" / 1.50mm Deep Cut 3 Med 4 High 6 5	Thickness: Blade & Housing: Speed: Pressure: Blade Depth: Multi Cut:	0.023" / 0.58mm Standard 3 Med 4 High 5 1
Notes: A fresh mat is needed to hold material. Small pieces of chipboard may require tape to stay in place		Notes: Use a normal household iron at its highest temperature setting. Apply direct heat and pressure to flocking for approx. 30 seconds. Peel protective liner when cool. Wash and dry garment inside out.
Emboss		Stamp
Thickness: Blade & Housing: Speed: Pressure: Blade Depth: Multi Cut:	0.016" / 0.41mm Standard 3 Med 5 Max 6 2	Thickness: Blade & Housing: Speed: Pressure: Blade Depth: Multi Cut:	0.0415" / 1.05mm Deep Cut 3 Med 4 High 4.5 1
		Notes: Use a fresh mat to keep material firmly in place.
CRI-Kits
Housing: Speed: Pressure: Blade Depth: Multi Cut:	CRI-Kits carrier 2 Low 3 Med 3 2	Notes: Before each project session always test settings on a scrap piece or an area of the page that will not be used first and adjust settings accordingly. Slower speeds = smoother lines.